Ceramic Glazes of Australia

Q For how long may the FastBright^TM colours be left before they cannot be washed off using water?

A There is no time limit for washing away colour from your piece or from brushes. A damp sponge and running water is all that is required.

Q Can FastBright^TM colours be thinned with water?

A No, these colours rely upon the special Fast-Drying medium to dry within a short time. Adding water greatly increases this drying time.

Q Is there any surface preparation necessary?

A Yes, always clean the ceramic or glass surface with very clean hot water or a small amount of methylated spirits to remove grease and dust.

Q Is it possible to apply too much colour?

A Yes, more than three heavy coats when brushing (undiluted) will cause cracking during heat treatment. When brushing use two heavy coats only, or, four coats if colour is diluted with medium.

Q What surfaces can I decorate?

A All glazed ceramic surfaces and glass surfaces may be decorated with FastBright^TM colours.

There are different temperatures used for each of these, please refer to the FastBright^TM Easy Guide sheets for details.

Q Do I need any special skills for printing FastBright^TM colours?

A No, and simple instructions are included to make printing an easy, effective method of decorating.

Q If brush-strokes are visible before firing will I see these after the firing?

A Yes, whatever texture is visible beforehand will also be there after the firing. To reduce the visibility of brush strokes, thin with a small amount of medium, or, apply two very light coats, always allowing to dry in between.